Site Information

Cross Bar Register

This Cross Bar Register is used as a custom replacement part for our Cross Bar. It is dimensionally similar to the Cross Bar from our Modular Roll Bar Rack Mount system however, it was designed for the user to weld these registers in place wherever they would like. The registers are machined from ¾” x 1 ½” cold finished steel flat bar. The registers have a full complement of radiuses machined into them for a smooth finish after installation. There has also been a large radiused groove placed in the bottom of the bar, for ease of alignment when installing the register onto a roll bar tube.

Currently there are two variations of these bars, two hole and eight hole configurations which are approximately 6” and 27” long.